Tie Down Insulated Cock Loop Instructions

It can be used as a base electrode in a tri-phase electrode set-up. You can plug in a second plug (ensuring it is from another channel) into the other end of the conductive rubber.

Instructions

1. If you plan on using cord or elestic then thread it through the loops before fitting the electrode to your body.
2. Place the insulated cock loop around your cock and balls with the plastic insulator on top. Use electrolube to ensure you get good contact between the conductive rubber and your skin.
3. Attach a plug to one end of the conductive rubber.
4. For the second electrode, I recommend either a cock loop of self-adhesive monopole pad electrode. Place the electrode either on your glans or just under it.
5. Attach the second plug to the other electrode.
6. Plug your cable into your control box and ensure all power levels knobs are set to zero output.
7. Turn on your power box, select your favourite settings and slowly turn up the power.

Tips For Use

• Always use conductive lube with conductive rubber. Never use silicone lube or oil-based products as they are an insulator.
• Silicone lube bonds to conductive rubber and creates an insulating coating on it rendering it unuseable so never use silicone lube.
• Water-based lubes will suffice if you have no electrogel.
• Cock loops should be a snug fit to allow for swelling of your penis without cutting off the blood supply.

Cleaning

The conductive rubber can be removed for cleaning, wash it in warm soapy water.

Wipe down the insulator with an anti-bacterial wipe. It is recommended that the insulator is painted before use but this is not essential.

Ensure everything is dry before storing away until your next stimming session.

Painting Advice

If you intend to paint your cock loop insulator follow these simple steps.

First, remove the conductive rubber and make sure the insulator is clean.

A light sanding of the surface will help paint to adhere to it correctly.

I recommend that you paint it to seal the surfaces with plastic paint such as Krylon Fusion For Plastic.

Apply a couple of layers of paint following the manufacturer's guidance on drying times.

Once dry refit the conductive rubber and enjoy your stimming.

Recommendations

I highly recommend using Electrogel when using conductive rubber electrdoes and my preference in the E-Stim Systems Electrogel which you can get from their UK site or US site.

Disclosure

Disclaimer - These instructions contain affiliate links and if you purchase something when you follow one of these links I may receive a small commission at no cost to you. For more information check out my disclosure page.